Setting
45
Ceiling
When this function is "On ", the picture is top/b ottom
and left/right reversed. This function is used to project
the image from a ceiling mounting the projector.
Rear
When this function is "On", the picture is left/right
reversed. This function is used to project the image to
a rear projection screen.
Ceiling
Rear
Setting
Input search
This function detects the input signal automatically.
When finding a signal, the search will stop. Use the
Point 7 8 buttons to select one of the following.
Off. . . . . Input search does not work.
On1... . Input search works under the situation
below.
• When pressing the INPUT butt on on the
top control.
• When pressing the COMPUTER button or
VIDEO button on the remote control.
On2... . Input search works under the situation
below.
When turning on the projector with
pressing the POWER ON/STAND-BY
button on the top control or on the remote
control.
• When pressing the COMPUTER button or
VIDEO button on the remote control.
• When missing the current input signal.
• When pressing the INPUT butt on on the
top control.
Note:
• While Input search is set On1 or On2, the status of Input and Lamp are displayed every time the
signal is switched.
• Only the input source selected at the last time can be detected.
• After searching every input signal and still can not detect any signal, Input search will operate
like below:
When pressing the INPUT button, Input search will select input source other than previous
one.
When pressing the COMPUTER button, Input search will stop at the previous COMPUTER
input.
When pressing the VIDEO button, Input search will stop at Video.
• If any of the INPUT button on the top control or COMPUTER/VIDEO button on the remote
control is pressed while Input search is on, Input search will stop and go back to the previous
input signal.
It is not available when On-Screen menu is displayed.