9
Part Names and Functions
A built-in micro processor which controls this unit may occasionally
malfunction and need to be reset. This can be done by pressing the RESET
button with a pen, which will shut down and restart the unit. Do not use the
RESET function excessively.
Rear Terminal
COMPUTER IN 1
DVI - I
MONITOR OUT
S-VIDEO
COMPUTER IN 2 /
COMPONENT IN /
COMPUTER /
COMPONENT
AUDIO IN
AUDIO IN
RVIDEOLUSB
SERVICE PORT
RESET
MCI
(MONO)
(VARIABLE)
AUDIO OUT
qw e r t y
o i u
iS-VIDEO
Connect the S-VIDEO output from video equipment to
this jack. (p18)
eAUDIO IN
Connect the audio output from video equipment
connected to ror ito this jack. (When the audio
output is monaural, connect it to L (MONO) jack.) (p18)
yAUDIO IN COMPUTER/ COMPONENT
Connect the audio output (stereo) from a computer or
video equipment connected to qor oto this jack.
(p17, 19)
rVIDEO
Connect the composite video output from video
equipment to VIDEO jack. (p18)
oCOMPUTER IN 2/ COMPONENT IN/ MONITOR OUT
This terminal is switchable and can be used for input
from a computer, video equipment (Component or RGB
Scart) or output to the other monitor. Optional cables
are required when using this terminal as component
input or RGB Scart 21-Pin Video input. (p61)
Set the terminal up as either Computer input or Monitor
output properly. (Used for Monitor out, this terminal
outputs only incoming signal from COMPUTER IN 1 DVI-
I terminal.) (p17, 19, 44)
uAUDIO OUT(VARIABLE)
Connect an external audio amplifier to this jack.
(p17- 19)
This terminal outputs sound from AUDIO IN terminal (e
or y).
tUSB (Series B)
When operating the connected computer with the
remote control, connect USB port of your computer to
this connector with a USB cable. (p17)
wSERVICE PORT
This jack is used to service this projector.

✽

Part Names and Functions

✽

Do not press this button. This button is used for optional
accessories.
qCOMPUTER IN 1 DVI-I
Connect output signal from a computer (Digital/Analog
DVI-I type) or Multi Card Director (optional) to this
terminal. (p17)