If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
●No picture problems : See No.1 ~ No.2
●Imaging problems : See No.3 ~ No.14
●Other problems : See No.15 ~ No.18
●USB problems : See No.19 ~ No.20
Problems | Points to check with possible solutions | |
1. No picture | [ ] Check that the power cord is correctly | |
| connected. If the problem persists, turn off | |
Indicator status: Off | the monitor power for a few minutes, then | |
turn it back on and try again. | ||
| ||
Indicator status: Blue | [ ] Check the Brightness setting. | |
|
| |
Indicator status: Yellow | [ ] Switch the signal Input by pressing the input | |
| signal selection button on the front control | |
| panel. | |
| [ ] Try pressing a key on the keyboard, or | |
| clicking the mouse. | |
|
| |
Indicator status: Slowly flashing | [ ] Try pressing the power button | |
Yellow |
| |
|
| |
Indicator status: Flashing Yellow | [ ] Try turning the PC on. | |
(twice for each) |
| |
|
| |
2. Following messages | These messages appear when the signal is not | |
appear. (Error messages | inputted correctly, even if the monitor | |
shown below will remain | functions properly. | |
on the screen for 40 | [ ] When the image is displayed correctly after a | |
seconds.) | short time, there is no problem with the | |
monitor. (Some PCs do not output the signal | ||
| ||
| soon after powering on.) | |
| [ ] Check that the PC is turned ON. | |
| [ ] Check that the signal cable is properly | |
| connected the PC or graphics board. | |
| [ ] Switch the signal input by pressing the Input | |
| Signal Selection button on the front control | |
| panel. | |
|
|