Both Side of Center Part of the Monitor

English

3.Adjust the “height”, “front and back position” and “angle” of the monitor (L568-AS only).

Grip both side of the center part of the monitor and move slowly (refer to the right figure.)

(1) Adjust the height of the monitor. To

Move Slowly

heighten, push the monitor backward. To lower, pull the monitor forward.

(2) Adjust the position and angle of the monitor.

(3) If necessary, fine adjust the height of the monitor.

4. Turn on the monitor’s main power and then switch on the PC’s power.

The monitor’s power indicator will light up (blue). If an image does not appear, refer to the “6. TROUBLESHOOTING” for advice. Whenever finished, turn off the PC and the monitor.

5. When using the software in the EIZO LCD Utility Disk: Connect the upstream port of the monitor to the downstream port of the USB compliant PC or another hub with the USB cable.

After connecting the USB cable, the USB function can be set up automatically. For further details about the software, refer to the readme.txt in the CD-ROM.

NOTE

zAdjust brightness of the screen depending on the brightness of your environment. Too dark or too bright of a screen can cause eyestrain.

zBe sure to take adequate rests. A 10-minute rest period each hour is suggested.

2-3. Connecting Two PCs to the Monitor

Two PCs can be connected to the monitor through the DVI and the D-Sub mini 15 pin connector on the back of the monitor.

Selecting the Active Input

The Input signal selection button on the control panel can be used to select either DVI or D-Sub as the active input at any time. Every time the button is pressed, the input changes. When switching the signal, the kind of the input signal (Analog or Digital) is displayed for a few seconds on the right top corner of the screen.

Input Signal

2. CABLE CONNECTION 15