English
18 2. CABLE CONNECTION
5. Press the power button while pressing the Input Signal Selection

button.

The Input Selection menu is appeared on the screen.
6. Change the input selection setting of the connector in the Input

Selection menu to “ADC”.

Press Enter button to complete the setting and the menu closes.
7. Switch on the PC’s power.
The monitor’s power indicator will light up (blue).
If an image does not appear, refer to the “7.TRO UBLESHOOTING” (p. 41)
for additional advice.
Whenever finishing your operation, turn off the PC and the monitor.
NOTE
zWhen changing the signal connector except ADC, open the Input Selection menu
again and change the setting to “Standard”.
zTo reset the setting in the <Others> menu through ScreenManager, the settings
of Input Selection will revert to the default setting.
zWhen turning on the monitor, the kind of the input signal (Signal1 or 2/Analog or
Digital) is displayed for a few seconds on the right top corner of the screen.
zAdjust brightness of the screen depending on the brightness of your
environment.
zBe sure to take adequate rests. A 10-minute rest period each hour is suggested.
ENTER
AUTO
SIGNAL
1 - 2 MODE
Input Signal
Selection Button
Mode Button Enter Button
Control Buttons
(Left, Bottom, Up, Right)
Power Button Power Indicator