Eizo SX3031W 1, 2, 3

Chapter 5 Reference

5-1 Attaching an Arm

The stand can be removed and replaced with an arm (or another stand) to be

attached to the monitor.

[Attaching]

1 Lay the LCD monitor on a soft cloth spread over on a stable

surface with the panel surface facing down.

2 Remove the stand. (Prepare a screwdriver.)

Unscrew the four screws securing the unit and the stand with the

screwdriver.

3 Attach the monitor to the arm or stand.

Secure the monitor to the arm or stand using the screws speciﬁ ed in the

user’s manual of the arm or stand.

5-2 Cleaning

Clean the monitor periodically to keep the monitor clean and extend its life.

Cabinet

Clean the cabinet with a soft cloth dampened with little mild detergent.

LCD Panel

• Clean the LCD panel with a soft cloth such as cotton cloth or lens cleaning

paper.

• Remove persistent stains gently with a cloth dampened with little water, and

then clean the LCD panel again with a dry cloth for better ﬁ nishing.

Attention

• When attaching an arm or stand,

follow the instructions of their user’s

manual.

• When using another manufacturer’s

arm or stand, conﬁ rm the following in

advance and select one conforming to

the VESA standard. Use M4 × 12 mm

screws supplied with the monitor.

– Clearance between the screw holes:

100 mm × 100 mm

– Thickness of plate: 2.6 mm

– Strong enough to support weight of

the monitor unit (except the stand)

and attachments such as cables.

• Attach an arm or stand to meet the

following tilt angles of the monitor.

– Up 45 degrees, down 45 degrees

(Within operating range)

• Connect the cables after attaching an

arm.

Attention

• Never use any solvents or chemicals,

such as thinner, benzene, wax,

alcohol, and abrasive cleaner, which

may damage the cabinet or LCD

panel.

NOTE

• Optional ScreenCleaner is

recommended for cleaning the panel

surface.

SX3031W_UM_EN.indd 23SX3031W_UM_EN.indd 23 5/29/2007 1:46:10 PM5/29/2007 1:46:10 PM