Eizo T1501, T1502 1, 2

Chapter 2 Settings and Adjustments

2-2 Screen Adjustment

Digital Input

When digital signals are input, images are displayed correctly based on the

preset data of the monitor.

Analog Input

The monitor screen adjustment is used to suppress ﬂ ickering of the screen or

adjust screen position and screen size correctly according to the PC to be used.

To use the monitor comfortably, adjust the screen when the monitor is set up for

the ﬁ rst time or when the settings of the PC in use are updated.

The auto-adjustment function works in the following cases:

• When a signal is input into the monitor for the ﬁ rst time

• When a signal is input into the monitor for the ﬁ rst time after the

resolution or refresh rate of input signals is changed

[Adjustment Procedure]

Automatic Adjustment

1 To adjust screen automatically [Screen]

(1) Choose <Screen> from the <Auto Adjustment> menu, and press .

(2) Select “Execute” with or , and press .

(3) Flickering, screen position, and screen size are corrected by the auto-

adjustment function.

If satisfactory adjustment cannot be obtained with the auto-

adjustment function, perform the adjustment following the

procedure below. When the screen is displayed correctly, go to step

4 “Range Adjustment”.

Advanced Adjustment

2 Run the Screen Adjustment Program.

Load the EIZO LCD Utility Disk on the PC, and start the Screen

Adjustment Program compatible with the PC in use.

After the program starts up, perform the adjustment in step 3 following the

instructions of the program.

Attention

• Wait 30 minutes or more from

monitor power on before starting

adjustments.

Attention

• This function works correctly when

an image is fully displayed over

the display area. It does not work

properly when an image is displayed

only on a part of the screen (DOS

prompt window, for example) or

when a black background (wallpaper,

etc.) is in use.

• This function does not work correctly

with some graphics boards.

• “Auto in Progress” appears on the

screen during auto adjustment.

NOTE

• Use “Screen Adjustment Program” on

the supplied EIZO LCD Utility Disk.

NOTE

• For how to start the Screen

Adjustment Program, refer to

“Readme.txt” ﬁ le. You can run the

program directly from the start menu

of the disk.

• If no adjustment program is available

for your PC, display a checkerboard

pattern on the screen (see below) and

go to the following steps.

T1501_UM_EN.indd 11T1501_UM_EN.indd 11 5/28/2007 11:22:57 AM5/28/2007 11:22:57 AM