English
4. TROUBLESHOOTING
If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
|
| *The bracket < > indicates the function of ScreenManager | |
|
| Problems | Points to check with possible solutions |
1. | No picture | Check that the power cord is correctly | |
| • | Indicator status: Off | connected. |
| If the problem persists, turn off the monitor | ||
|
|
| |
|
|
| power for a few minutes, then turn it back on |
|
|
| and try again. |
| • | Indicator status: Green | Check the Contrast and Brightness. |
| • Indicator status: Flashing Green | Try pressing a key on the keyboard, or clicking | |
|
|
| the mouse. (p. 18) |
| • Indicator status: Flashing Yellow | Try pressing the AUTO/FINE MODE button or | |
|
|
| control pad or turn the monitor off and then on. |
|
|
| (p. 19) |
2. | Following messages appear. (Error | These messages appear when the signal is not | |
| messages shown below will remain | input correctly, even if the monitor functions | |
| on the screen for 30 seconds.) | properly. | |
| • "No signal detected" error | When the image is displayed correctly after a | |
|
| message appears. | short time, it is not a monitor's problem. (Some |
|
| PCs do not output the signal soon after | |
|
|
| |
|
|
| powering on). |
|
|
| Check that the PC is turned ON. |
|
|
| Check that the signal cable is properly |
|
|
| connected to the PC or graphics board. |
|
|
| Switch the signal input by pressing the |
|
|
| |
|
|
| control panel. |
| • "Out of range" error message | Use the graphics board's utility software to | |
|
| appears. Whenever an error signal | change the frequency setting. (Refer to the |
|
| message appears, the signal | manual of the graphics board). |
|
| frequency will be displayed in red. |
|
|
| (Example) |
|
|
|
|
|
|
|
|
|
4. TROUBLESHOOTING 21