DESIGN Brick 70™
©Elation Professional, Los Angeles Ca. 19 www.ElationLighting.com
~ Edit
Scene 250
Time--
Input By
Outside
manual scenes edit
Rec. Controller
XX~XX
Automat. scenes rec
Remarks:
1) If the fixture does not receive a DMX signal the menu display will flash
repeatedly.
2) SPED: Adjust the hold time for each scene in built-in chase programs.
3) FADE: Adjust the fade time between each scene in the built-in programs.
8.1 Function Mode:
8.1.1 “Set DMX Address” - DMX address setting – This function is used to set or
adjust the fixture’s starting DMX address. Every device controlled by DMX has to have a
unique starting address. The addressing feature is what allows DMX to function
properly. The DMX address of a fixture is what allows it to communicate with a controller
properly. The DMX addressing also allows the fixture to ignore any DMX information
coming from the controller that is not meant specifically for the fixture. Because each
fixture is connected in a daisy-chain fashion it is imperative to assign a proper and
unique starting DMX address to each and every fixture. The DMX address is
non-destructive and will remain in the fixture’s memory even when the power to the unit
is switched off. Memory is backed-up and retain by an internal power source that should
last about five years. For proper DMX addressing see Section 9/Page 30 of this user
manual.
8.1.2 “Value Display” - Display the DMX 512 value of each channel
With this function you can display the DMX 512 value of each channel. The display will
automatically detail the changing DMX values as they are received from the controller.
8.1.3 “Set to Slave” - Slave setting for Master/Slave Operation
With this function, you can define the device as slave for operation in Master/Slave
mode. Each slave setting will have a different function for a dynamic lightshow without a