Elation Professional 72MKII - page 18

DESIGN LED 72MKII™
©Elation Professional, Los Angeles Ca. 17 www.ElationLighting.com
In the case of the Design LED 72MKII™, which is capable of controlling up to 15 DMX
channels, you should set the starting DMX address of the first unit to 1, the second unit to 16
(15 + 1), the third unit to 31 (15 + 16), and so on.
Note: During start-up the Design LED 72MKII™ will automatically detect whether a DMX
data signal is being received or not. If a DMX data signal is being received, the display will
show "A.XXX" (XXX representing the actual DMX address). If the fixture is not receiving a
DMX signal the display will flash "A.XXX" (XXX representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not receiving a
DMX signal), please check the following:
- The 3-pin or 5-pin XLR plug (cable with DMX signal from controller) may not be
connected or is not inserted completely into the DMX input jack.
- The DMX IP cable adapter is fitted incorrectly.
- The DMX controller is switched off or defective.
- The DMX cable or connector is defective.
- A DMX terminator has been inserted into the last fixture in your DMX chain.