Elation Professional 4, DMX-Branch Model: DMX-Branch X4

DMX-Branch/4™ Operation

Be sure the power is disconnected before making any type of

connections Connect the output signal from your DMX control-

ler to the input jack of the DMX-Branch X4. Use the four output

channels to send DMX signal to your DMX ﬁxtures. Dasiy-chain

the DMX output. Remember that the pack is only place a DMX

signal may be split. If you are not using the output jack to link

DMX-Branch X4’s together be sure the terminate switch is in the

in position (Terminate).

Each of the four output channels have a set LED indicators, a

red and a green. Without an incoming DMX signal the red LEDs

will function as a power indicator. When a DMX signal is applied

the LED’s will serve two functions:

1. These indicator will indicate pin polarity. A solid red LED will

indicate pin 3 is hot (positive). A solid green LED will indicate

pin 2 is hot (positive).

2. When shorted or bad cable is connected to a particular chan-

nel the LED will turn off. This is useful to immediately identify

bad cables or lines.

©Elation Professional® www.elationlighting.com DMX-Branch/4™ Instruction Manual Page 7

©Elation Professional

Elation Headquarters:

4295 Charter Street Los Angeles, CA 90058 USA

Tel: 323-582-2650 / Fax: 323-582-2610

web: www.elationlighting.com / E-mail: info@elationlighting.com

Model: DMX-Branch X4™

SPECIFICATIONS:

Power: 110V/60Hz

Fuse: 5 x 100mA GMA (Internal)

Working Position: Any

Weight: 6.5 Lbs.

Size: 13” x 3 1/8” x 7 1/8”

Duty Cycle: None