CobaltCo4

Instrument Microphone

Specifications

Element

Dynamic

 

Neodymium magnet structure

Frequency Response

50 Hz to 18 kHz

Polar Pattern

Cardioid

Impedance

Low-Z balanced (600 Ohms)

Sensitivity

 

Open Circuit Voltage

2.8 mV/Pa (-51dBV) re 1 Pa*

 

1 Pa = 94dB SPL

Microphone Connector

3-pin, XLR-type

Polarity

Pin 2 positive, referenced to pin 3

 

with positive pressure on diaphragm

Finish

Durable polyurethane paint

Materials

Die cast zinc housing

Dimensions

 

Length

5.8 in. (148 mm)

Diameter

.92 in. (23 mm)

Shank

.46 in. (12 mm)

Weight

 

Net

12 oz. (340 grams)

Accessories included

Stand adaptor (black)

Standard Placement & Use Guidelines

1.Always point the microphone at the desired source of sound, and away from any unwanted sources.

2.The microphone should be located close to the sound source to minimize interference from other potential sound sources.

3.Use the 3-to-1 rule when using multiple microphones. Place each microphone three times farther from other microphones as from the desired sound source.

4.Minimize over-handling of the microphone to reduce unwanted mechanical noise.

5.Working close to the microphone will increase the bass tone and also provide increased gain-before-feedback.

12000 Portland Avenue South, Burnsville, MN 55337 Phone: 952/884-4051, Fax: 952/884-0043

www.electrovoice.com

© Telex Communications, Inc. 9/2003

Part Number 38109-907 Rev. B

U.S.A. and Canada only. For customer orders, contact Customer Service at:

800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

+ 49 9421-706 0 Fax: + 49 9421-706 265 Other International locations. For customer orders, contact Customer Service at:

+ 1 952 884-4051 Fax: + 1 952 736-4212 For warranty repair or service information, contact the Service Repair department at:

800/553-5992 or 402/467-5321

For technical assistance, contact Technical Support at:

800/392-3497 or 952/736-4656 Specifications subject to change without notice.

Page 2
Image 2
Electro-Voice Co4 manual Specifications, Standard Placement & Use Guidelines