Electro-Voice M2 Balanced Low-Impedance Outputs, Headphones, Tape Record Outputs, Master Outputs

M2 High-Performance Stereo Mixing Console

M2 High-Performance Stereo Mixing Console

Specifications	Input Specifications		Output Specifications
Conditions:	Input Channel Equalization:		Output Impedance,
1. 0 dBu = 0.775 V rms.	+15 dB low cut/boost centered at 80 Hz		Balanced Low-Impedance Outputs:
2. 0 dBv = 1.0 V rms.	+15 dB mid cut/boost variable from		150 ohms
3. Measurements are referred to a 1-	250 Hz – 5 kHz		Headphones:
kHz, 0-dB sine wave input unless	+15 dB high cut/boost centered at 12 kHz		100 ohms
noted.	Input Channel Gain Control Range:		Aux Sends:
4. 120-V, 60-Hz ac line voltage.	44 dB variable (-60 - -16 dB)		75 ohms
Frequency Response, Mic Input to	Peak Indicator Threshold (on each		Insert Sends:
Master Output (EQ flat):	input channel):		600 ohms
20 – 20,000 Hz (+1/-2 dB)	3 dB before clipping (post-EQ signal)		Tape Record Outputs:
Total Harmonic Distortion, 20 – 20,000	Microphone Inputs,		2,000 ohms
Hz at +14 dBu Output into 600 ohms:	Number:		Maximum Output Level,
<0.1%		12 or 16	Master Outputs:
Equivalent Input Noise	Type Connector:		+24 dBu (12.3 volts)
(150 ohm termination):		Low-impedance, balanced,	Headphones:
-127 dBv, microphone input		3-pin XLR-type	Channel Insert Sends:
Output Noise at Balanced Outputs:	Polarity:		+20 dBu (7.75 volts)
-95 dB residual output noise		Pin 2 positive	Tape Record Outputs:
Maximum Voltage Gain,	Maximum Input Level:		Power Requirements:
Microphone Input to Master and	+16 dB with gain control at minimum		115 or 230 volts, 50 or 60 Hz. 36 watts
Mono Output:	Input Impedance:		Dimensions, (see Figure 1)
84 dB		4,000 ohms	Height:
Microphone Input to Aux Send	Phantom Power:		109 mm (4.29 in.)
1–2 :		+ 48 volts	Width:
76 dB	Line Inputs,		12-channel: 520 mm (20.47 in.)
Microphone Input to Aux Send	Number:		16-channel: 632 mm (24.88 in.)
3–4 :		12 or 16	Depth:
86 dB	Type/Connector:		509 mm (20.03 in.)
Aux Return 1–2 to Master Output :		High-impedance, balanced,	Weight,
16 dB		¼-inch TRS jack	M2/12: 12 kg (26.45 lb)
Crosstalk, Adjacent Inputs:	Polarity:		M2/16: 14 kg (30.80 lb)
>-70 dB at 1 kHz		Tip positive
Crosstalk, Adjacent Outputs:	Maximum Input Level:
>-70 dB at 1 kHz	+24 dBu with gain control at minimum
Level Displays,	Input Impedance:
Type:		10,000 ohms
10-segment LED Ladders	Aux Inputs,
Range:	Number:
-20 to +6 dB		4 (two stereo)
Reference:	Type/Connector:
0 VU = +4 dBu (1.23 volts)		High impedance, unbalanced
		¼-inch phone jack
	Polarity:
		Tip positive
	Nominal Input Level:
		+ 4 dBu (1.23 volts)
	Input Impedance:
		10,000 ohms

600 Cecil Street, Buchanan, MI 49107

616/695-6831, 616/695-1304 Fax

MIXING CONSOLE—High-Performance © Telex Communications, Inc. 1998 • Litho in U.S.A. Part Number 535339 — 9850

4