Electro-Voice P2000 warranty Precision SeriesTM, Power Amplifier

				P2000
				Precision SeriesTM
				Power Amplifier
				• 560 watts per channel
				at 8 ohms, 900 watts per
				channel at 4 ohms, 1,200
				watts per channel at 2 ohms
				• Neutrik Speakon® output
				connectors allow use of
				heavy-gauge speaker wire
				for low-loss connections
				• Extremely low (<0.01%)
				dynamic distortion ensures
				excellent sound quality
				• Three-year parts-and-labor
				warranty
SPECIFICATIONS		Voltage Gain, 1 kHz, Any Mode, Constant-		Load Protection:
Conditions:		Gain Option:1		Start-up/shutdown transients; dc fault;
1. 0 dBu = 0.775 V rms.			26 dB	infrasonic signals; low ac line voltage;
2. Dual-mode ratings are for each channel,		Input Sensitivity, 1 kHz, Dual Mode for		nonlinear signal limiter
both operating, unless noted.		800 Watts into 4 Ohms:		Output Topology:
3. 120-volt ac line voltage maintained			0 dBu (775 mV)	True complementary symmetry with
throughout testing.		Maximum Input Level (reference 1 kHz):		ungrounded collectors (no mica insulators
Continuous Rated Output Power (20-			+20 dBu (7.75 V)	means better heat transfer)
20,000 Hz at less than 0.1% THD, both		Input Impedance (per channel,		Output Devices,
channels driven per EIA RS-490),		20-20,000 Hz), Balanced:		Total Number: 32 devices
Dual Mode, 2 Ohms:			20 kilohms	Pd(max) Rating: 250 watts
1,000 watts		Phase Response (at rated power, any		Ic (collector current): 20 amps dc
Bridged Mode, 4 Ohms:		mode, 10-30,000 Hz):		Tj(max): 200 °C (392 °F)
2,000 watts			± 22.5 degrees	Controls and Switches,
Dual Mode, 4 Ohms:		THD Plus Noise at 1 kHz (at rated power,		Rear:
800 watts		measurement bandwidth 80 kHz):		Hi-Lo-Cut Filter(On/Off); Bridged Mode
Bridged Mode, 8 Ohms:	<0.01%			switch (Bridged/Normal); Limiter mode
1,600 watts		IMD (SMPTE) (60 Hz/7 kHz, typical, at		(Fast/Slow); Circuit ⊥ To Chassis
Dual Mode, 8 Ohms:		rated power; see Figure 2):		Switch (Grounded/Ungrounded); Input
500 watts	<0.01%			Routing (Parallel Mono or Dual Stereo)
Continuous Rated Output Power (1 kHz,		DIM 30 (composite square-sine wave		Front:
1% THD, both channels driven per EIA		band-limited to 30,000 Hz):		Two calibrated input level controls;
RS-490),	<0.01%			power switch
Dual Mode, 2 Ohms:		DIM 100 (composite square-sine wave		Front-Panel Indicators:
1,200 watts		band-limited to 100,000 Hz):		Five LED’s per channel (10 total) for power
Bridged Mode, 4 Ohms:	<0.01%			on, input signal, output signal, limiter
2,400 watts		Rise Time (10% to 90% at rated power,		on and protect on
Dual Mode, 4 Ohms:		any mode):		Connections,
900 watts			<2.5 microseconds	Input:
Bridged Mode, 8 Ohms:		Slew Rate, Any Mode:		3-pin female XLR-type connectors for
1,800 watts			>35 V/microsecond	each channel in parallel with a 3-pin
Dual Mode, 8 Ohms:		Damping Factor, Any Mode:		male XLR-type output connector for
560 watts	>300			easy signal routing; the XLR connec-
Power Bandwidth (+0, –1 dB, reference		Amplifier Protection:		tors are wired according to the IEC 268
1 kHz), Any Mode, 4 Ohms:			Excessive output voltage; shorted loads;	standard: pin 1 shield, pin 2 positive,
10-30,000 Hz			excessive phase shift; rf interference;	pin 3 negative
Frequency Response			overtemperature; excessive back EMF;	Output:
(+0, –3 dB, reference 1 kHz/1 watt) :			In-rush current limiter	Neutrik Speakon® NL4MP for channels
<10-30,000 Hz	__________________			A, B and for bridged mode
		1. Configured for constant-gain option, all Precision SeriesTM
				Power:
			amplifiers, regardless of power rating, have a maximum
				12-gauge, 3-wire, permanently attached
			voltage gain of 26 dB.

power cable; no ac plug supplied