21
DISHWASHER WON’T FILL
• Check to see if the water supply is turned on.
• Add 1/2 cup of water to the bottom of the unit
and start again.
DISHWASHER HAS AN ODOR
• Soiled dishes left in dishwasher too long can
create an odor. Use Rinse cycle.
• There will be a “new” smell when first
installed. This is normal.
• Check to see if unit is draining properly (See
Dishwasher Does Not Drain Properly, page
21).
REMOVING SPOTS AND FILM
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses may
also get spots and film for a number of reasons
(See Glassware/Flatware Spotted or Cloudy, page
19).

To remove build-up, spots and film, clean

using the following instructions:

1Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2Do not add detergent.
3Select the NORMAL WASH cycle. Press
START/CANCEL pad and close door.
4Allow dishwasher to run until it begins the
second fill. Open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
5Close and latch door and allow cycle to
finish.
CYCLE TAKES A LONG TIME
• Check to see if cycle is in a water heating
delay.
• Check to see if the delay start option has
been selected.
• Check to see if the sanitize option has been
selected.
NOTE

If these conditions persist, a home water

softener should be considered.

Solutions to Common Problems