28 Changing The Filter
To replace your pure advantageTM water filter:
It is not necessary to turn the water supply off to change the filter. Be ready to wipe
up any small amounts of water released during the filter replacement. The bottom
of the filter housing includes two small water drainage holes, so be sure to remove
any stored food from the top shelf.
1Turn Off the ice maker power switch (see page 23 for
more about turning off the ice maker).
2Push the filter release button to the right of the
cartridge to disconnect it.
3Slide the old filter cartridge straight out of the housing
and discard it.
4Unpackage the new filter cartridge and slide it gently
into the filter housing until it stops against the snap-in
connector at the back of the housing.
5 Push firmly until the cartridge snaps into place.
When fully engaged, the front of the filter cartridge
should be flush with the filter release button.
6Turn On the ice maker power switch (see page 23 for
more about turning on the ice maker).
7Press a drinking glass against the water dispenser
while checking for any leaks at the filter housing. Any
spurts and sputters that occur as the system purges air
out of the dispenser system are normal.
8After filling one glass of water, continue flushing the
system for about three minutes.
9Press and hold the Filter Status button on the Ice &
Water Dispenser control panel for 3 seconds. The light
flashes red, amber, and green to indicate the Filter
Status has been reset.
NONO
NONO
NOTETE
TETE
TE
The o-rings on a new water filter are lubricated. To ensure a good
seal, please do not remove this lubricant.
241540100_eb_sxs_Use&Care_En.pmd 1/22/2004, 10:34 AM28