Electrolux 241857202 To attach refrigerator handle, Removing Stainless steel Doors and handles

Door Removal / reversal Instructions

3.Remove screw and dovetail button and install on other side, moving hole plugs from corresponding holes to opposite side.

To attach refrigerator handle:

Figure 1 Style Handles

1.Secure bottom of handle with screws.

2.Secure top of handle with screws.

Figure 2 Style Handles

1.Start with handle offset away from door. Place bottom of handle over dovetail button, swing handle into an upright position and pull upward, locking it into place.

2.Secure top of handle with screws.

To Attach Trim:

1.Slide both trim locks out of trim.

2.Insert new adhesive trim locks contained in your literature pack.

3.Install trim to handle by sliding under base of handle. Carefully align trim and press down at trim lock locations.

4.Use rubbing alcohol to remove any adhesive residue from old trim lock locations.

To Remove Refrigerator Handle:

(Handles may be easier to reverse while doors are off.)

1. Remove two screws attaching handle to top of refrigerator door.

2. Remove button plug using edge of putty knife.

3.Remove screw on side of refrigerator door and remove handle.

4.Reverse freezer and

refrigerator handles as	Figure 3 - Handle Reversal
shown in figure 3.

To attach Refrigerator Handle:

1. Secure side of handle to door and replace plug button.

2. Secure handle to top of door.

Refrigerator Door Without Trim

NOTE

Trim lock must be removed and installed by sliding over the two donut shaped areas.

7

Figure 1 Figure 2

Removing Stainless steel Doors and handles

CAUTION

Use care when using tools near surface of stainless steel doors to avoid scratching.

To Remove Doors

Stainless steel doors are not reversible. Follow these steps to remove doors.

1.Remove toe grille and top hinge cover.

2.Remove top hinge and lift freezer door off of center hinge pin. Set door aside.

3.Unscrew center hinge bin using adjustable wrench and save for reassembly. Ensure plastic washer stays on hinge pin.

4.Lift refrigerator door off

of bottom hinge and set aside.

5. Remove center hinge and shim by removing inside screw and loosening two outside screws enough to allow hinge to slide out.

6. Remove bottom hinge. Reinsert two outside

screws in holes and tighten.

7.Reverse steps 1 - 6 to reinstall doors

To Remove Handles

1.Firmly hold freezer handle while loosening set screws with 3/32” allen wrench. Remove freezer handle.

2.Repeat step 1 for refrigerator door.