Electrolux 24 Dishwasher WON’T Fill Error Codes, Dishwasher has AN Odor, Removing Spots and Film

Solutions to Common Problems 21

DISHWASHER WON’T FILL

ERROR CODES

•Check to see if the water supply is turned on.

•Add 1/2 cup of water to the bottom of the unit and start again.

DISHWASHER HAS AN ODOR

•Soiled dishes left in dishwasher too long can create an odor. Use Rinse cycle.

•There will be a “new” smell when first installed. This is normal.

•Check to see if unit is draining properly (See Dishwasher Does Not Drain Properly, page 20).

REMOVING SPOTS AND FILM

Hard water can cause lime deposit build-up on the interior of the dishwasher. Dishes and glasses may also get spots and film for a number of reasons (See Glassware/Flatware Spotted or Cloudy, page 19).

To remove build-up, spots and film, clean

using the following instructions:

1Load clean dishes and glasses in normal manner. Do not load any metal utensils or silverware.

2Do not add detergent.

3Select the NORMAL WASH cycle. Press START/CANCEL pad and close door.

4Allow dishwasher to run until it begins the second fill. Open door and pour 2 cups of white vinegar into the bottom of dishwasher.

5Close and latch door and allow cycle to finish.

NOTE

In certain situations which are critical to the machines function and safe operations.

Error 01

Leak Detector - When water is detected under the tub.

Error 02

Thermistor - When thermistor/turbidity module fails

Error 03

Wash Pump - Wash pump not operating Error 04

Drying Damper - Drying damper not operating Error 05

Upper Fan - When in the dry cycle, the control board does not receive proper speed feedback from the upper fan

Error 06

Lower Fan - When in the dry cycle, the control board does not receive proper speed feedback from the lower fan

Error 07

Drain Valve - When in the drain mode, the control board does not receive proper position feedback from the drain valve

Error 08

Tactile or touch switch - Control board has verified a switch on the user interface is bad or shorted

Error 09

Communications - Communication failure be- tween main user board and power supply

Error 10

Mains Relay - Failure in the mains power relay Error 11

Drain Valve - Time out before finding a state for the drain valve

Error 12

Drain Valve - The drain valve is running when it should be off

Error 13

System wide - Lost control of the State Machine

If these conditions persist, a home water softener should be considered.