Active carbon filter
Cleaning
Replacing the lamps
12
This filter is used when the hood functions for internal recycling. The original AEG active carbon filter should be used (see Special accessories).
It is neither washable nor reusable.
In normal cooking conditions, we recommend that it be replaced every 4 months.
To replace the active carbon filter, push the locking tabs E inwards and the filter downwards (see diagram on pag. 4). When ordering a new active carbon filter, indicate the model description and fan hood serial number. This information can be found on the rating plate inside the appliance.
Filters can be ordered at any AEG retailer.
Warning: always disconnect the hood from the mains power supply before cleaning it.
Never insert pointed objects in the motor’s protective grille.
Wash the outside surfaces using a mild detergent solution. Never use caustic detergents or abrasive brushes or pow- ders.
Only ever clean the switch panel and filter grille using a damp cloth and mild detergents.
It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard.
Always turn off the electricity before replacing lamps:
1)Remove the grid in order to check the lamps and replace them if necessary.
2)Unscrew the lamps that do not work and replace them with 40W max lamps (E14).
If the light does not function, check that the lamps are properly
Attention
Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions.
