Operating Instructions
11
Adjust the water softener to the water hardness setting for your area
as shown in the table.
1 It is only possible to adjust the water hardness setting when no pro-
gramme is running. If you have accidentally started a programme (a
LED stays on permanently), the programme must be stopped by press-
ing the appropriate button.
0 1. The dishwasher must be switched off.
2. Manual setting:
Open the door on the dishwasher.
3. Remove the lower rack from the
dishwasher.
4. Turn the water hardness switch
to0or 1.
5. Re-position the lower rack.
6. Electronic setting:
Press the softener and function but-
tons simultaneously and keep them
pressed.
7. In addition press the ON/OFF button.
8. The LED indicators for the water softener and function buttons flash.
9. Press the softener button again.
– At first the LED indicator for the water softener button will light up
continuously for 5 seconds and then begin to flash.
– The number of flashes corresponds to the hardness setting.
– The sequence of flashes is repeated several times after a 5 second
pause.
10. Each time you press the water-softener button the hardness setting
will go up by 1.
(Exception: Hardness setting 1 follows hardness setting 5).
– If the hardness setting is changed, the LED indicator for the water-
softener button will confirm the change by remaining illuminated
continuously for 5 seconds and then flashing again.
– The number of flashes corresponds to the new hardness setting.
– The sequence of flashes is repeated several times after a 5 second
pause.
11. Once the hardness setting is correctly adjusted, press the ON/OFF but-
ton.
The hardness setting is then stored.