Installation Instructions
THE INSTALLATION SPACE
DIMENSIONS AND CLEARANCES
|
|
|
|
| 3" |
|
| |||||||||
| *Finished Width |
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 7" |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 7" |
|
|
|
|
|
|
|
| |||
84 1/2" max | Electrical |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
83 1/2" min | Area |
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
| 74" | ||||||||||||
Finished |
|
|
|
| ||||||||||||
Opening |
|
|
|
|
|
|
|
|
|
|
|
|
| From Floor | ||
| 24" |
|
|
|
|
|
|
|
|
|
|
|
| to Bottom | ||
|
|
|
|
|
|
|
|
|
|
|
| of Electrical |
5" Water Supply 5" 3 1/2"
3 1/2"
*The finished cutout width must be: 41-1/2″ for 42″ models
41"
Case Width
*84" From | |
at Rear | Floor to |
| Top Frame |
42" Frame-to-Frame
Depth Including
Handles 26-7/8"
*Shipping height
The front height may be adjusted from
Water and Electrical Locations
The opening must be prepared with the electrical and water supply located as shown.
The cutout depth must be 24″
The refrigerator will project forward, slightly beyond adjacent cabinets, depending on your installation.
Additional Specifications
•A 120 volt, 60Hz, 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded
Note: GFI (ground fault interrupter) is not recommended.
•Water line can enter the opening through
the floor or rear wall. The water line installed should be 1/4″ O.D. copper tubing between the cold water line and water connection location. The line should be long enough to extend to the front of the refrigerator. Installation of an easily accessible shutoff valve in the water line is required.
Product Clearances
These refrigerators are equipped with a 2 position door stop. The factory set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted.
130° Door Swing | 90° Door Swing |
A B
|
|
|
| C |
|
| D |
|
|
|
|
|
| D |
Models | A | B | C | D |
42″ | 16″ | 24″ | 4″ |
Allow minimum clearances for Freezer door (Dimension A) and Fresh Food door (Dimension B) for a full 130° door swing and to allow for drawer removal.
Four inch (4″ ) minimum clearance is required when door swing is adjusted to 90°. If the 90° door stop position is used, drawer access is maintained, but drawer removal is restricted.
See illustrations, pages 18 and 19, to determine door swing interaction with adjacent cabinets or countertops.
17