Operating Instructions

Malfunction

Water runs out from under the washing machine.

Fabric softener is not added, compartment

Àfor fabric softener is filled with water.

Appliance does not spin, water in the drum.

Possible Cause

Threaded fitting on the water inlet hose is leaking.

The inlet hose has a leak.

The drain pump cover is not tight.

Washing is caught in the door.

Suction cap in the fabric softener compartment is not correctly fitted or is blocked.

Rinse Hold selected.

Remedy

Tighten the inlet hose con- nections.

Check the inlet hose and if necessary replace it.

Tighten cover by turning clockwise.

Stop the program, remove the washing caught in the door, start a new program.

Clean detergent dispenser drawer, place suction cap firmly in position.

Deselect Rinse Hold.

Washing is not spun properly, water is still visible in the drum.

Drain hose is kinked.

Drain hose to high.

Drain pump is blocked.

Remove kink.

Check installation instructions.

Switch off the machine and pull the plug out of the socket, clean the drain pump.

It is not possible to open the door.

Remnants of detergent are building up in the detergent dispenser drawer.

The water drainage system is blocked.

The door is locked for safety reasons.

Water tap is not fully open.

The inlet hose filter in the coupling of the inlet hose at the tap is blocked.

The inlet valve filter in the coupling of the inlet hose at the appliance is blocked.

Clean the blockage.

Wait 1-2 minutes after the end of the program.

Open water tap fully.

Clean filter.

Clean filter.

This is probably due to using Rinse water is cloudy. a detergent with a high sili-

cate content.

No negative impact on the rinsing results, try using liq- uid detergent.

27

Page 27
Image 27
Electrolux 50520 manual Appliance does not spin, water in the drum Possible Cause