27
Programming possibilities

The electronic control system of your laundry dryer provides you with

the possibility to adapt some functions of the dryer permanently to

your requirements.

Purpose Execution
"Laundry protection": If
you want to "lock" the
selected drying
programme (the
selected programme
setting cannot be
changed during the
drying process with the
programme selector or
with the SPECIAL CARE
or QUICK button):
When "Washing
Protection" is enabled,
the drying programme
always runs at reduced
heater power (SPECIAL
CARE Function).
When a drying programme is set with the programme
selector and the START button has been pressed:
- Hold the SPECIAL CARE button depressed for five
seconds.
The programme execution display flashes for five seconds
and the laundry protection is then switched on.
If an attempt is nevertheless made to change the
programme setting, the programme execution display
flashes; after pressing the SPECIAL CARE or QUICK button,
it flashes for five seconds; on turning the programme
selector it flashes until the programme selector is returned
to the initial setting.
To cancel the laundry protection:
- Hold the SPECIAL CARE button depressed for five
seconds.
The programme run indicator flashes for five seconds, then
it is static for five seconds; laundry protection is cancelled.
If you always want to be
reminded by an audible
signal at the end of the
programme:
1) Ensure that the programme selector is not in the LIGHT
or OFF position.
2) Hold the AUDIBLE SIGNAL button depressed for at least
five seconds.
The AUDIBLE SIGNAL display lights; a short audible
signal is heard.
The audible signal is now programmed.
If you want to cancel this setting:
3) Proceed as described under item 1) and 2).
The display AUDIBLE SIGNAL disappears.
If you remove
condensation via an
external condensation
drain off and wish to
permanently suppress
the EMPTY WATER
indication:
1) Set the programme selector to LIGHT.
2) Hold the AUDIBLE SIGNAL button depressed for five
seconds.
The PROGR. TIME display shows U for normal function
and & for external condensation drain off.
3) Briefly press the AUDIBLE SIGNAL button to choose
between U and & .
4) Turn the programme selector.
The EMPTY WATER indicator is now suppressed.