Operating Instructions
33
What to do, if ...

Try to rectify minor faults on the dishwasher with the aid of the

instructions given here. If you call an engineer to resolve a of fault

listed here, or to repair a fault caused by incorrect use or installation, a

charge will be made even if the appliance is in guarantee.

...Error messages are displayed.

If any of the indicators in the control panel, as listed in the table below,

are flashing or are illuminated, you can probably rectify the fault your-

self.

Malfunction Possible cause Remedy
The programme indicator for
the selected programme is
flashing. The ^ indicator is
continuously illuminated,
error code Å10 is displayed
in the multi-display: there is
no water running into the
dishwasher.
The tap is blocked or furred
with lime-scale. Clean the tap.
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Press the button for the
selected programme,
then cancel the pro-
gramme by pressing
RESET (see chapter:
“Starting a pro-
gramme”); clean out the
filters (see chapter:
“Cleaning the filters”).
The water inlet hose has not
been correctly laid. Check hose installation.
The programme indicator for
the selected programme is
flashing, error code Å20 is
displayed in the multi-display.
The siphon is blocked. Clean out siphon.
The water drain hose has
not been correctly laid. Check hose installation.
Error code Å30 is displayed
in the multi-display.
The leak prevention system
has been triggered.
Turn off the tap and
contact your local Serv-
ice Force Centre.