Installing and Connecting Up
34
Installing and Connecting Up

Installing

1 Important: The new appliance is only to be installed and connected up
by an approved installer.
Please observe this instruction, otherwise the guarantee will not cover
any damage that may occur.
The veneer or plastic coverings on kitchen units around the appliance
must be bonded with heat resistant adhesive (100 °C). If plastic cover-
ings or the adhesive are not sufficiently temperature resistant, then the
covering may distort or come loose.
In respect of fire protection, the appliance corresponds to type Y
(EN 60335-2-6). Only this type of appliance may built into positions
with a high cupboard or wall on one side.
The cooking surface must have a heat protective base permanently
fixed in position. The distance from the base to the underside of the
cooking surface must be at least 50 mm. The edges of the cut out must
be coated with a water-proof material. The cooking surface must be
built-in such that the TOUCH CONTROL control panel is at the front
(see Fig.).