It is not necessary to attach the reinforcement beam to the table surface, as it is held in place by a specially designed moulding, which is incorporated in the hob units flanges.
Installation in work tops with a base unit underneath
If the hob is to be installed on top of a base unit, a board must be mounted underneath the hob (e.g. 16 mm chip board).
Seal all joints with aluminium tape. The board can be mounted as shown in the diagram.
This installation method prevents the flames from being extinguished if you close the door of the base unit hard.
If the back panel of the cupboard unit is of thin 4 mm material, it will need to be reinforced.
This procedure will prevent the gas being blown out if the cupboard door is slammed shut.
Min. 140 mm
Min. 16 mm
Min. 140 mm |
Min. 16 mm |
16
