Operating Instructions
26

Washing cycle is complete/Removing the washing

Once the washing programme has come to an end, END illuminates on
the programme progress display.
If RINSE HOLD was selected, the display beside the START/PAUSE
button flashes.
0 1.After a rinse hold, the water must first be pumped out:
Either press the START/PAUSE button (the water is pumped out and
the washing is spun according to the completed programme; After
the START/PAUSE button is pressed again, the spin speed can still also
be changed during spinning),
or
Turn the programme selector to OFF and then to PUMP OUT and press
the START/PAUSE button (the water is pumped out without spinning),
or
Turn the programme selector to OFF and then to SPIN or SHOR T SPIN
and press the START/PAUSE button (the water is pumped out and the
washing is spun or gently spun).
At the end of this programme step, the END indicator will illuminate.
2. Open the door.
As soon as the DOOR indicator lights up green, the door can be opened.
3. Remove the washing.
4. Turn the programme selector to OFF.
5. Close the water tap.
6. After washing, pull out the washing detergent dispenser drawer slightly
so that it can dry out. Leave the door ajar so that air can circulate in
the drum.
3 If the OVERDOSING indicator illuminates, then too
much detergent was used in the washing programme
just completed. Observe the dosing recommendations
of the detergent manufacturer as well as the load quantity for the next
wash.
Important! If the washing machine is not to be used for a long period:
Close the water tap and disconnect the washing machine from the
electricity mains.