25
If you are unable to remedy the problem by following the above
suggestions, please contact your local Service Force Centre.
1Warning! Repairs to the appliance are only to be carried out by quali-
fied service engineers. Considerable danger to the user may result from
improper repairs.
3If the appliance has been operated incorrectly, the visit from the service
technician or dealer may not take place free of charge, even during the
warranty period.
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic
signal sounds
The On/Off sensor field has
been covered up, e.g. by a
cloth
Do not place any objects
on the control panel
Display changes between
two heat settings
Power Management is re-
ducing the power of this
cooking zone
See the section “ Switching
the power function on and
off”
Power Management is ac-
tive, maximum load per
side reached
Use cooking zones on other
side
f flashes Unsuitable cookware Use suitable cookware
No cookware on the cook-
ing zone
Put cookware on zone
Diameter of the base of the
cookware is too small for
the cooking zone
Use suitable cookware
(min. 120mm)
Cookware not completely
covering cross
Place cookware centrally
over the cross
_ is lit Overheating protection for
the cooking zone has been
triggered
Switch off the cooking
zone. Switch the cooking
zone on again
Safety cut-out has been
triggered
Switch off the cooking
zone. Switch the cooking
zone on again
e and number are dis-
played
Electronics fault Disconnect the appliance
from the electrical supply
for a few minutes (Take the
fuse out of the house’s wir-
ing system)
If after switching on again,
e is displayed again, call
the customer service de-
partment
Problem Possible cause Remedy