Electrolux E30GC74GPS specifications Gas Slide-In Cooktop Specifications

Models: E30GC74GPS

1 4
Download 4 pages 41.38 Kb
Page 2
Image 2
30" Gas Slide-In Cooktop Specifications

Gas Slide-In Cooktop

E30GC74GPS

30" min.

29 7/8"

13" Manual background 2"Manual background max. Manual backgroundManual background

cabinet

depth

Optional 9" stainless steel backsplash (attaches to wall)

Side inset 5/8"

1" min. recommended distance between

 

rear edge of cutout and nearest combustible

 

surface above countertop

29 15/16"**

3"

2"

 

 

 

30" min. for

 

 

unprotected cabinet

 

 

24" min. with

25"

18"

protected bottom

surface

min.

 

 

7 3/4"

**Applies only in case

 

of countertop backwall

 

7" min. to nearest

 

combustible wall

 

(either side of unit)

7 1/2"

3/8"

7 1/4"

2" dia. Manual background opening to route power cable

22 1/8"

11/8" 24" max.

1" countertop Manual background overhang

2

1/2"

Support

 

platform

291/8"

 

 

4" x 4" opening to route gas supply

29 3/16"* 29 15/16"*

*Both cutout dimensions are critical to proper cooktop installation.

Due to variations in countertop materials it is recommended to undercut finished dimension 2915/16" and adjust upon installation of cooktop.

30" Gas Slide-In Cooktop Specifications

Product Weight – 95 Lbs.

Voltage Rating – 120V/ 60Hz/15 Amp

Connected Load (kW Rating) @120 Volts = 0.001kW (For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

Amps @120 Volts = 0.008 Amps

Always consult local and/or national electric and gas codes.

Cooktop ships with 3/4" factory regulator.

Lp conversion kit supplied.

Plan installation to have electrical connection, gas shutoff valve, and pressure regulator accessible from front of cabinet. Locate 120V grounded outlet in a 4"W x 5"H area on rear wall, 16" above floor, aligned center with cooktop.

Cabinet and/or countertop must completely enclose recessed portion of cooktop. Respect cutout dimensions and clearances and ensure that all contact surfaces are solid and level.

Overhead cabinetry should not exceed a 13" maximum depth.

Allow 30" minimum clearance between top of cooktop and bottom of unprotected wood or metal overhead cabinetry.

Absolute minimum horizontal distance between overhead cabinets installed to either side of appliance must be no less than maximum width of appliance.

Allow 24" minimum clearance when bottom of wood or metal overhead cabinet is protected by not less than 1/8" flame-retardant millboard covered with not less than No. 28 MGS sheet steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper.

Allow 1" minimum clearance between rear edge of cooktop and nearest combustible surface above countertop. If required clearance can not be maintained, then optional stainless steel backsplash or noncombustible backsplash material must be used – otherwise installation will require custom cabinet and countertop dimensions.

Allow 7" minimum clearance from edge of cooktop to nearest combustible wall on either side of unit.

It is recommended that drawers not be used beneath cooktop.

To reduce risk of fire when using overhead cabinetry, install vent hood that projects horizontally a recommended minimum of 7" beyond bottom of cabinets.

Gas Slide-In Cooktop model E30GC74GPS is NOT approved to be used over any Electrolux ICONSingle Wall Oven.

Gas Slide-In Cooktop model E30GC74GPS (without optional backsplash) is approved to be used in combination with an Electrolux ICONDowndraft Vent. (Refer to Slide-In Cooktop /Downdraft Vent Countertop Preparation Specifications page and on web.) Proper combination installation will require cooktop power cord to be relocated to underside of unit. (For details, refer to 30" & 36" Gas Slide-In Cooktop Power Cord Relocation Instructions on web.)

Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxicon.com for detailed instructions.

Optional Accessories

When replacing an existing cooktop with countertop cutout deeper

than 7-1/4" and less than 8-1/2", order free Depth Adjustment Filler Kit – (903051-9100).

9" Stainless Steel Backsplash – (903048-9100).

Black Knobs Kit – (903049-9110).

USA 250 Bobby Jones Expressway Augusta, GA 30907 1-877-4electrolux (1-877-435-3287) electroluxicon.com

High standards of quality at Electrolux Home Products, Inc. mean we are

constantly working to improve our products. We reserve the right to change

CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4 1-800-265-8352 electroluxicon.ca

specifications or discontinue models without notice.

E30GC74GPS 05/08

© 2008 Electrolux Home Products, Inc.

Printed in the U.S.A.

Page 2
Image 2
Electrolux E30GC74GPS specifications Gas Slide-In Cooktop Specifications