Electrolux E30WD75GPS Warmer Drawer Specifications, Optional Accessories, Stand-Alone

Warmer Drawer

E30WD75GPS professional series

26" 23 3/8"

Warmer Drawer
Stand-Alone
	9 7/8" min.
Installation	10 1/4"max.
		28 1/2" min.	23 5/8"min.
Power cord	4 1/2" min.
		28 3/4" max.	24"max.
location (right	required
center rear)	distance
	to floor
			Full plywood
7/8"			base required to
			support 100 lbs.

Overall depth with drawer fully extended (including handle) – 44 1/8"

30"

11 1/4"

30" Warmer Drawer Specifications

•Product Weight – 49 Lbs.

•Voltage Rating – 120V/450W/60 Hz/15 Amps

•Connected Load (kW Rating) @120 Volts = 0.45kW (For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

•Amps @120V = 3.75 Amps

•Full plywood base required, capable of supporting 100 Lbs.

•Base must be level and cabinet front must be square.

•Warmer Drawer can be used alone, or is approved to be used in combination with any Electrolux ICON™ Wall Oven. (Refer to Combination Installation Specifications and drawing on this page.)

•Warmer Drawer can be used alone, or is approved to be used in combination with any Electrolux ICON™ built-in product. (Refer to Combination Installation Specifications pages on web.)

Optional Accessories

•ServeWare – (5304447729).

Warmer Drawer / Single Wall Oven	1	1
		/2"
Combination Installation	min.

28 1/2"	1	24"*
min.	28 /2"min.	(critical
	28 3/4"max.	dimension)
28 7/8"
max.	30"min.
3
1 /4"
†
min.
9 7/8" min.
10 1/4"max.
Two 3" wide		Electrical
x 3/4" thick
planks must		junction box
be installed,		location
capable of
supporting
200 lbs.

4" x 4" opening to route armoured cable

Bottom of oven cutout

		*Critical dimension –
11	5/8"	MUST be applied
		**Electrical junction
min.*
		box for Wall Oven
		must be lower than
		the Warmer Drawer
		cutout
		†
		Maximum height
		depends on critical
		5
		dimension (11 /8")
3"
max.**

Warmer Drawer/Wall Oven Combination Specifications

•To support Wall Oven when using in combination with Warmer Drawer, two 3"-wide x 3/4" thick planks must be installed as a base, capable of supporting 200 Lbs. Do NOT use full base, since planks are necessary to allow for proper air displacement.

Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxicon.com for detailed instructions.

USA • 250 Bobby Jones Expressway • Augusta, GA 30907 • 1-877-4electrolux (1-877-435-3287) • electroluxicon.com	High standards of quality at Electrolux Home Products, Inc. mean we are
	constantly working to improve our products. We reserve the right to change
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxicon.ca
	specifications or discontinue models without notice.

E30WD75GPS 05/08 © 2008 Electrolux Home Products, Inc. Printed in the U.S.A.