Electrolux E39WD75GTT Oven Cutout, Electric Single, High-Speed Ovens Specifications

High-Speed Oven/Electric Single Wall Oven/ Warmer Drawer Combination Installation

For detailed product dimensions and installation specifications, refer to model-specific product page and installation guide on web

E30SO75FPS
E30SO75ESS	21 11/16"min.
High-Speed	223/16"max.
Oven Cutout	2"
	(visible
	gap)*
E30EW75GPS
E30EW75GSS
Electric Single	28 1/2"min.
Wall Oven Cutout
	28 7/8"max.
E30WD75GPS
	13/4"min.†
E30WD75GSS
E30WD75GTT	9 7/8"min.
Warmer Drawer
Cutout	10 1/4"max.
	41/2"min.
	required

24" min. 30"min.

20 1/4"

16 3/4"

22 3/8" min.
22 7/8" max.	C
	L
28 1/2"min.	24" min.**
	(critical
29" max.	dimension)

28 1/2"min.

29" max.

240V/60 Hz grounded electrical outlet should NOT be located within shaded area

Full plywood base required to support 150 lbs.

Two 3" wide by 3/4" thick planks must be installed, capable of supporting 200 lbs.

Bottom of

oven cutout

11 5/8"min.**

(critical

dimension)

3"max. ††

*Minimum 2 5/8" clearance required from bottom of Built-In High-Speed Oven cutout to top edge of Wall Oven’s faceplate, leaving a 2"visible gap between both product faceplates

**Critical dimension – MUST be applied

†Maximum height depends on critical dimension (11 5/8")

††Electrical junction box for Wall Oven must be lower than the Warmer Drawer cutout

Full plywood base	Electrical junction
required to support	box location
100 lbs.	4"x 4" opening to route
	armoured cable

High-Speed Oven / Electric Single Wall Oven / Warmer Drawer Combination Installation Specifications

•Always consult local and/or national electric codes.

(Refer to product-specific electrical specifications on this page.)

•Minimum 24"deep cutout dimension is critical for proper combination installation, to ensure that each built-in product’s faceplate will fit flush against cabinet front.

•Bases must be level and cabinet front must be square.

•Minimum 4-1/2"required distance from bottom of Warmer Drawer cutout to floor.

•Respect critical dimensions as noted for proper installation of built-In products.

•Minimum 23-1/4" clearance needed for Wall Oven door depth when open.

30" High-Speed Ovens Specifications

•Product Weights – (E30SO75FPS/E30SO75ESS) 115 Lbs.

•Voltage Rating – 240V/60 Hz/15 or 20 Amps

•Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line.

•Connected Load (kW Rating) @ 240 Volts = 3.3kW

•Amps @ 240 Volts =13.2 Amps

•Full base of solid plywood or similar material required, capable of supporting 150 Lbs.

•Minimum 2-5/8"clearance required from bottom of High-Speed Oven cutout to top edge of Wall Oven’s faceplate, leaving a 2"visible gap between both product faceplates.

30" Electric Single Wall Ovens Specifications

•Product Weights – (E30EW75GPS) 178 Lbs. / (E30EW75GSS) 175 Lbs.

•Single phase 3- or 4-wire cable, 120/240 or 120/208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line.

•Connected Load (kW Rating) @ 240/208 Volts = 4.0/3.0kW

•Amps @ 240/208 Volts =16.6/14.4 Amps

•To support Wall Oven, two 3"-wide x 3/4" thick planks must be installed as a base, capable of supporting 200 Lbs. Do NOT use full base, since planks are necessary to allow for proper air displacement.

30" Warmer Drawers Specifications

•Product Weights – (E30WD75GPS/E30WD75GSS) 49 Lbs. / (E30WD75GTT) 41 Lbs.

•Voltage Rating – 120V/450W/60Hz/15 Amps

•Connected Load (kW Rating) @120 Volts = 0.45kW

(For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

•Amps @120V = 3.75 Amps

•Full base of solid plywood or similar material required, capable of supporting 100 Lbs.

Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxicon.com for detailed instructions.

USA • 250 Bobby Jones Expressway • Augusta, GA 30907 • 1-877-4electrolux (1-877-435-3287) • electroluxicon.com	High standards of quality at Electrolux Home Products, Inc. mean we are
	constantly working to improve our products. We reserve the right to change
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxicon.ca
	specifications or discontinue models without notice.

SO_EW_WD INST 03/08 © 2008 Electrolux Home Products, Inc. Printed in the U.S.A.