Electrolux E42BS75EPS specifications Built-In Refrigerator Specifications, Cutout, Dimensions

Built-In Refrigerator

E42BS75EPS professional series

Power cord location
(right top rear)	25 3/8"
41" case width

	84"	Cutout
	from	Dimensions
	floor
	to	(A) Finished
	top		A
		opening:
	frame	831/2"min.
		841/2"max.
*83 3/4"
at rear		(B) 411/2"
		(C) 24"

B7"x 7" electrical

				area
	3"
				74"from
C				floor to
				bottom of
		Water
				electrical
31/2"		supply		area
			31/2"
5"

26 7/8"	42"
		frame to frame
including		Water line inlet location
handle
		(left bottom front)

*Shipping height. (Front height may be adjusted from 83-1/2" to 84-1/2" by adjusting leveling legs a max. of 1".)

Door-Swing Clearances	123/16"				41"
				130°			16"
Refrigerator equipped with 2-position door
				Door Swing
stop. Factory set to 130°, adjustable to
90° if clearance to adjacent cabinets or
wall is restricted.
Notes:						41"
A 4" min. door clearance is required when
								7
°		90°						23 /8"
using 90 door stop position. Drawer access				Door Swing				behind
is maintained, but removal is restricted.
								frame
To determine door swing interaction with
adjacent cabinets and countertops refer to
Product Installation Guide on web at							24"
electroluxicon.com.			4"min. to wall

42" Built-In Refrigerator Specifications

•Product Weight – 610 Lbs.

•Voltage Rating – 120V/ 60Hz/15 or 20 Amps

•Connected Load (kW Rating) @120 Volts = 0.65kW

(For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

•Amps @120 Volts = 5.4 Amps

•Always consult local and/or national electric & plumbing codes.

•Cutout must be prepared with electrical and water supply located as shown. When possible, recess copper water line and electrical outlet.

•Water line can enter opening through floor or rear wall. Copper tubing recommended between cold water line and water connection location. Water line tubing recommended is 48" minimum length by 1/4" diameter. Installation of easily accessible shutoff valve in water line required.

•Optimum door swing factory set for 130°. When installing next to wall where handle may make contact, allow 4" minimum clearance for 90° door swing. At 90° door stop position, drawer access will be maintained but removal will be restricted.

•Refrigerator must be placed on level surface of hard material, same height as flooring. Surface must support approximately 1500 Lbs. when fully loaded. Unit equipped with 4-point leveling.

Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxicon.com for detailed instructions.

USA • 250 Bobby Jones Expressway • Augusta, GA 30907 • 1-877-4electrolux (1-877-435-3287) • electroluxicon.com	High standards of quality at Electrolux Home Products, Inc. mean we are
	constantly working to improve our products. We reserve the right to change
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxicon.ca
	specifications or discontinue models without notice.

E42BS75EPS 03/08 © 2008 Electrolux Home Products, Inc. Printed in the U.S.A.