Installation instructions
Hints on safety
This appliance must be installed and connec- 
ted by a qualified electrician or competent person. Please observe this instruction, otherwise the warranty will not cover any da- mage which may occur.
During the installation and in case of a service fai- lure the appliance must not be connected to the mains.
The general rules for the operation of electric ap- pliances, the provisions by the competent electri- city supply board and the specifications of these instructions for installation have to be strictly ad- hered to.
Building into the kitchen worktop
Electrical safety is to be ensured by professional 
installation.
Protection against accidental contact according to the regulations set by VDE or other local autho- rities must be ensured by correct installation of the appliances. The same refers to the back of the appliance which, even in case of
. Note down the data from the rating plate of your appliance in the printed rating plate form in this manual. These numbers are needed in case of service calls.
Installation dimensions
The opening in the cabinet must correspond to the standard dimensions. The necessary information can be found in the dimensional sketch.
. The separation between the lower surface of the hob and the parts of the furniture below it must be at least 20 mm
. The lateral separation between the sides of the hob and the cabinet must be at least 50 mm, and must be at least 55 mm from the rear panel.
With regard to the protection against overheating of surrounding furniture surfaces this appliance corresponds to type Y. This appliance or the
distance from worktop |
opening to the rear wall |
55 mm |
20 mm |
distance from worktop opening to the left or right side wall or to a high cupboard
50 mm
20 mm
R5
12
