18 electrolux installation instructions

Installation Instructions

Safety instructions

The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc.)

Installation may only be carried out by a qualified electrician.

The minimum distances to other appli- ances and units are to be observed. Anti-shock protection must be provided by the installation, for example drawers may only be installed with a protective floor directly underneath the appliance. The cut surfaces of the worktop are to be protected against moisture using a suitable sealant.

The sealant seals the appliance to the work top with no gap.

The sealant seals the appliance to the work top with no gap.

Do not use silicon sealant between the appliance and the work top.

Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened.

WARNING!

Risk of injury from electrical cur- rent.

The electrical mains terminal is live.

Observe connection schematic.

Observe electrical safety rules.

Ensure anti-shock protection through correct installation by a qualified electrician.

The appliance must be connected to the electrical supply by a qualified electrician.

IMPORTANT!

Risk of injury from electrical cur- rent.

Loose and inappropriate plug and sock- et connections can make the terminal overheat.

Have the clamping joints correctly in- stalled by a qualified electrician.

Use strain relief clamp on cable.

In the event of single-phase or two- phase connection, the appropriate mains cable of type H05BB-F Tmax 90°C (or higher) must be used.

If this appliance’s mains cable is damaged, it must be replaced by a special cable (type H05BB-F Tmax 90°C; or higher). Please contact your local Service Force Center for further advice.

A device must be provided in the electri- cal installation which allows the appli- ance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm

Suitable isolation devices include line protecting cut-outs, fuses (screw type fuses are to be removed from the hold- er), earth leakage trips and contactors.

Page 18
Image 18
Electrolux EHP 60060 X user manual Installation Instructions