8electrolux
Problem
Water flows on the rear plate of the refrigerator.
Water flows into the re- frigerator.
Water flows on the ground.
The temperature in the appliance is too low.
The temperature in the appliance is too high.
Possible cause
During the automatic defrosting process, frost defrosts on the rear plate.
The water outlet is clogged.
Products prevent that water flows into the water collector.
The melting water outlet does not flow in the evaporative tray above the compressor.
The temperature regulator is not set correctly.
The temperature regulator is not set correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same time.
There is no cold air circulation in the appliance.
Solution
This is correct.
Clean the water outlet.
Make sure that products do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de- crease to room temperature be- fore storage.
Store less products at the same time.
Make sure that there is cold air cir- culation in the appliance.
Replacing the lamp
1.Disconnect the mains plug from the mains socket.
2.Remove the screw from the lamp cover.
3.Remove the lamp cover (refer to the illus- tration).
4.Replace the used lamp with a new lamp
of the same power and specifically de- signed for household appliances. (the maximum power is shown on the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7.Connect the mains plug to the mains socket.
8.Open the door. Make sure that the lamp comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In- stallation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
