23
Cabinet is placed at a location where
the ambient temperature corresponds
to the climate classification*,for which
the appliance is designed.
* See on the rating plate on the insid e
of the appliance.
The following table shows which
ambient temperature is correctfor
each climate classification.
Climate
classifi-
cation
for an ambient
temperature of
+10°C to +32°C
+16°C to +32°C
+18°C to +38°C
+18°C to +43°C
SN
N
ST
T
If the cabinet is placed in a corner and
the side withthe hinges facing the
wall, the distance between the wall
and the cabinet must be at least 230
mm to allow the door to open enou gh
so that the shelves can be removed.
Check that the drain hose at the rear
of the cabinet dischargesin tothe drip
tray.
The power plug must be accessible
after installation of th e cabinet.
When the water system is startedfor
the first time.
The following should be carried ou t
when the refrigeratoris correctly
connected to the water supply in the
building:
Open the tap on the waterconnection
and start up the refrigerator. The water
system main valve opens and the
system starts to fill up. Wait for five
minutes.
Unpack the filter provided and connect
it as follows:
- Remove the filter protectivecap and
insert the filter connector intothe filter
seat and turn as shown in the
illustration (2) until the filter engages
and the projectionon the filter
cartridge is opposite the mark on the
plastic cover.See also the illustration
and the instructionson the inside of
the service hatch.
12
- Unlock the waterdispenser. See the
section "The water dispenser
functions" Select carbonated water
and drain off about 1.5 litres(2.5 pints)
of water.There may be some air to
start with.
Connect the gas cylinder provided as
follows:
- Takeout the gas cylinder from plastic
bag and screwthe gas cylinder into
the adapter (3) for this purpose, which
is located in the cabinet, doing this by
hand without tools.