locknut. The locknut must be correctly fitted to avoid water leaks.
Attention! NOT all dishwasher models of have inlet and drain hoses provided with a locknut. In this case, this facility is not available.
If the appliance is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few mi- nutes before connecting the inlet hose.
DO NOT use connection hoses which have previously been used on an old ap- pliance.
This appliance has been fitted with safe- ty features which will prevent the water used in the appliance from returning back into the drinking water system. This appliance complies with the applicable plumbing regulations.
Water inlet hose with safety valve
After connecting the
Please take care when installing the water inlet hose:
•The electrical cable for the safety valve is in the
•If water inlet hose or the safety valve is damaged, remove the mains plug imme- diately.
•A water inlet hose with safety valve must only be replaced by the Service Force Centre.
Warning! Dangerous voltage
electrolux 23
Water drain connection
The end of the drain hose can be connected in the following ways:
1.To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink run- ning into the machine.
2.To a stand pipe provided with venthole, minimum internal diameter 4 cm.
max 85 cm
cm | min 40 cm | |
max 400 |
|
|
|
| |
|
|
|
The drain hose can face either to the right or left of the dishwasher
Ensure the drain hose is not bent or squash- ed as this could prevent or slow down the discharge of water.
The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine.
If you use a drain hose extension, its internal diameter must be no smaller than the diam- eter of the hose provided.
Likewise the internal diameter of the cou- plings used for connections to the waste out- let must be no smaller than the diameter of the hose provided.
When connecting the drain hose to an under sink trap spigot, the entire plastic mem- brane (A) must be removed. Failure to re- move all the membrane will result in food particles building up over time eventually blocking the dishwasher drain hose spigot