Operating sequence
1. Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning"- Instruction book part 1).
2.Check that there is rinse aid and salt
3.Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
4.Ensure that the spray arms can rotate freely.
5.Measure out detergent
Add the required amount of detergent into the dispenser according to the dosage quantity given in the "Washing programmes" chart.
Close the detergent dispenser lid.
6. Set the programme
The selection of a programme occurs with the door partially opened.
Turn the programme selector dial clockwise until the number of the programme you wish to select corresponds with the programme marker on the control panel.
9. Start the programme
Depress the On/Off push button and close the door, the machine will start.
If you wish to interrupt the washing programme at any time open the door and press this button again.
10. At the end of the washing programme
At the end of the programme the dishwasher will automatically stop.
11. Switch off the dishwasher
Switch off the dishwasher by opening the door and pressing the On/Off push button.
Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.
Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.
Important!
Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.
4
