or make a hole in the bottom of the appli-
ance.
Do not fill the rinse aid dispenser with
other products than the rinse aid, (dish-
washer cleaning agent, liquid detergent).
This can cause damage to the appliance.
Make sure that the spray arms can move
freely before you start a washing pro-
gramme.
The appliance can release hot steam if
you open the door while a washing pro-
gramme operates. There is a risk of skin
burns.
•Do not remove the dishes from the appli-
ance until the washing programme is
completed.
Care and cleaning
• Before you clean the appliance, deacti-
vate it and disconnect the mains plug
from the mains socket.
• Do not use flammable products or prod-
ucts that can cause corrosion.
• Do not use the appliance without the fil-
ters. Make sure that the installation of the
filters is correct. An incorrect installation
causes unsatisfactory washing results
and damage to the appliance.
• Do not use spray water or steam to clean
the appliance. Risk of electrical shock
and damage to the appliance.
Installation
• Make sure that the appliance is not dam-
aged. Do not install or connect a dam-
aged appliance, contact the supplier.
Remove all packaging before you install
and use the appliance.
• Only a qualified person must do the elec-
trical connection, the plumbing and the
installation of the appliance. This to pre-
vent the risks of structural damage or in-
jury.
• Make sure that the mains plug is discon-
nected from the mains socket during in-
stallation.
• Do not drill into the sides of the appliance
to prevent damage to hydraulic compo-
nents and electrical components.
Important!Obey the instructions in the
template supplied with the appliance:
To install the appliance.
To assemble the door panel.
To connect to the water supply and
drain.
• Make sure that the appliance is installed
below and adjacent to safe structures.
Frost precautions
• Do not install the appliance where the
temperature is less than 0 °C.
• The manufacturer is not responsible for
frost damage.
Water connection
• Use new hoses to connect the appliance
to the water supply. Do not use used ho-
ses.
• Do not connect the appliance to new
pipes or pipes not used for a long time.
Let the water flow for some minutes, then
connect the inlet hose.
• Make sure not to squash or cause dam-
age to the water hoses when you install
the appliance.
• Make sure that the water couplings are
tight to prevent a water leakage.
• The first time you use the appliance,
make sure that the hoses do not have
water leaks.
Electrical connection
• The appliance must be earthed.
• Make sure that the electrical information
on the rating plate agrees with the power
supply.
• Always use a correctly installed shock-
proof socket.
• Do not use multiple plugs and extension
cables. There is a risk of fire.
• Do not replace or change the mains ca-
ble. Contact the service centre.
• Make sure not to squash or cause dam-
age to the mains plug and cable behind
the appliance.
• Make sure that there is access to the
mains plug after the installation.
• Do no t pull the mains cable to disconnect
the appliance. Always pull the mains
plug.
Only for UK and Ireland. The appliance
has a 13 amp mains plug. If it is necessa-
ry to change the fuse in the mains plug,
use a 13 amp ASTA (BS 1362) fuse .
electrolux 3