Door Reversal
1.Disconnect the appliance from the electricity supply.
2.Remove all loose items, including food. Store food in a cool place.
3.Make sure a towel or cloth is at the base of the product to prevent it from slipping.
4.Carefully lean the appliance backwards, resting the top on a stool, or something similar, at least 30cm (12") from the floor. (care must be taken not to allow the appliance wheels to slip).
Do not support the appliance on the rear ventilation grille or condenser.
5.Remove level adjuster (A) from base of product retaining small cup spacer which is located around the threaded portion of the adjuster.
6.Remove the foot / hinge assembly (B) by removing screws marked (C).
7.Remove the door by lifting it slightly and carefully sliding it down off the top hinge pin
(F) by removing screw (G) and transfer to the opposite side.
8.Refit the door by carefully sliding it onto the upper hinge pin (F). Take the bottom hinge foot assembly (B) and transfer it over to the opposite side of the cabinet being careful to retain any spacing washer fitted onto the bottom hinge pin. Push the hinge foot assembly (B) into the door bearing using the pin of the foot for location. Three holes will then line up with the hinge foot and screws (C) should be used to secure the hinge.
9. Refit level adjuster in the opposite side of the | B | A | |
cabinet. | |||
|
|
The base of your product should now be in line with the diagram.
10. Stand the appliance upright.
C
18
