3.Two cabinet securing brackets are supplied with the installation pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture.
-To fit these brackets remove the two screws at the top left and right hand front corners of the cabinet.
-Position the two brackets as shown in the figure and replace the two securing screws.
Left hand | Right hand |
bracket | bracket |
1/a
4.Push the appliance into place. The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess.
5.To adjust the height proceed as follows:
-Loosen or tighten the two front feet.
-The rear feet are adjusted by turning the screw in the front kick plate to the left or right.
6.If necessary, pads are supplied for the rear feet to make sliding the appliance in and out of the recess easier. To fit the pads, press them onto the rear feet.
If required, the dimensions of these pads can be reduced by breaking them where marked.
2 | 1 |
B
3
- |
+ |
2Li89 |
2/a |
115° |
4 |
N.B. The joint cover (B) is to be assembled after hav- ing installed the appliance in the recess.
17
