IMPORTANT
This is a guide of product dimensions only. For complete installation instructions, refer to the manual provided with product.
installation guide
electrolux E:Line built-in dishwasher
Model: EX401ISB
dishwasher dimensions and pre-installation instructions
596mm
550mm
min. 818mm max. 898mm
2mm
820mm - 900mm
600mm
Note: Rear leg adjustment via screw at front
Loop drain hose and locate 10mm beneath benchtop
Waste |
Cold water supply |
Inlet hose supplied
240V switched power outlet Drain hose supplied
Note: Hole at bottom of spigot on sink drain must be drilled out completely. Position of spignot from base of dishwasher floor must be 300mm minimum. Maximum height of drain hose from floor must be 1000mm.
Notes:
•If the floor is not level, the levelling legs should be adjusted to fit
•The dishwasher must be fixed to the cabinets with the screws provided
•The entire plastic membrane from the sink trap to be removed before fitting and securing the drain hose
•Cold water connection is recommended
•Water flow rate10L/minute min.
•Water temperature 65° max.
•Water pressure cold,
•Water pressure hot,
Notes:
•Ensure that hoses are not crushed or kinked under or behind the dishwasher.
•After connecting hose to the tap, turn the tap on and check to ensure that there are no leaks.
All measurements in millimetres.
Page 1 of 2
Current as at Jul 2007.
© 2006 Electrolux Home Products Pty Ltd. EDIMDWEX401ISB