Grease and charcoal filter maintenance indicator
This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter).
On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled.
If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows:
Press button 1 to switch OFF.
Press buttons 3 and 5 simultaneously and hold them for 3 seconds. At first only the grease filter LED F will illuminate, but when the charcoal filter LED C illuminates the saturation indicator will be enabled.
To disable it: Press buttons 3 and 5 again simultaneously and hold them for 3 seconds, until the charcoal filter LED C goes out.
Grease filter LED (F)
LED F will start to flash when it is time to clean the grease filter.
Cleaning will be necessary after 40 working hours. Always comply with the cleaning instructions for the grease filter.
Charcoal filter LED (C)
The charcoal filter LED C will start to flash when the charcoal filter needs to be replaced.
This operation is necessary after approximately 160 working hours.
Resetting the saturation indicator
After cleaning or replacing the filters, press button 1 for 3 seconds until the grease filter LED F or the charcoal filter LED C stops flashing.
Warning! When resetting the saturation indicator it MUST be done in
After resetting the saturation indicator switch the hood OFF.
8
