Operating Instructions
31
Fabric softener was not
washed into machine;
drawer æ for condi-
tioner is filled with
water.
The conditioner insert has
not been correctly positioned
inside the conditioner com-
partment or is blocked.
Clean the detergent dis-
penser drawer and attach the
conditioner insert securely.
Washing is heavily
creased
Probably too much washing
was put into the drum.
Pay attention to the maxi-
mum load quantity (see Pro-
gram tables). In the case of
easy-care fabrics, select the
EASY IRON program.
Washing has not been
spun properly. Water is
left in the drum.
Drain hose is kinked. Remove the kink.
Maximum pump head (dis-
charge height 1 m from the
appliance’s base) is exceeded.
Contact your local Service
Force Centre. For pumping
heights over 1 m a conver-
sion kit is available as a spe-
cial accessory.
Drain pump is blocked.
Switch off the appliance and
pull out the mains plug.
Clean the drain pump.
Remnants of detergent
are building up in the
detergent dispenser
drawer.
Water tap is not fully open. Open the water tap fully.
The inlet hose filter in the
coupling inlet hose at the
tap is blocked.
Close the water tap. Unscrew
the inlet hose from the water
tap and from the appliance.
Clean the filter.
The rinsing water is
cloudy.
The cause is probably a
detergent with a high silicate
content.
No negative effect on the
rinse results; use a liquid
detergent if necessary.
Door cannot be
opened.
Door is locked for safety rea-
sons.
Wait for 1 or 2 minutes after
the end of the program.
Problem Possible Cau se Remedy