Electrolux LAVAMAT 54810 What to do if, Remedying small faults yourself

What to do if...

Remedying small faults yourself

If the programme progress display indicates one of the following fault codes during operation:

–END flashes 1x (problem with water inlet),

–END flashes 2x (problem with water outflow),

–END flashes 4x (door open),

please consult the following table.

After the fault has been remedied, press the START/PAUSE button

In the case of other fault messages (one or more flashing indicators on the programme progress display):

switch the appliance off and on again. Set the programme again. Press the START/PAUSE button.

If the fault appears again, please contact your local Service Force Cen- tre.

Problem	Possible cause	Remedy
	Power plug not plugged in	Connect the plug to a mains
	or problem with the fuse.	socket. Check the fuse.
Washing machine does	The door is not shut proper-	Close the door - there should
	ly.	be an audible click.
not work.
	The START/PAUSE button	Press the START/PAUSE but-
	was not pressed for long
		ton for longer.
	enough.
The door cannot be	The child safety device is ac-	Deactivate the child safety
closed.	tivated.	device.
The END indicator is
flashing 4 times, and si-	The door is not closed prop-	Close the door properly. Re-
multaneously an acous-	erly.	start the programme.
tic signal is sounding 4
times.
The END indicator is	The tap is turned off.	Turn on the tap.
		Turn off the tap. Unscrew the
flashing 1x, and simul-	The filter in the inlet hose
taneously an acoustic		hose, remove the filter and
	screw connection is blocked.
signal is sounding 1x.		clean it.
(Problems with the wa-	The tap is blocked by limes-	Check the tap and have it re-
ter inflow.)
	cale or is faulty.	paired, if necessary.

18