Electrolux LAVATHERM 57700 operating instructions Replace the interior light

Something not working?

Symptom	Possible cause	Solution
The drying process takes		Check the program
	SPECIAL CARE button	selection: SPECIAL CARE
unusually long. 4.5 hours
	pressed and too much	button appropriate only
after the beginning of the
	laundry filled-in	for laundry amounts up
drying process:
		to 2.5kg
- END display flashes
- acoustic signal sounds	Too much laundry	Reduce the amount of
- discontinuation of the	filled-in	laundry filled-in
drying process
		Pre-dry the laundry more
- error code C6 is displayed	Laundry too damp
		thoroughly

If after these checks, the tumble dryer still does not work, contact your local AEG Service Force Centre.

Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechani- cal or electrical breakdown.

Replace the interior light

￿A replacement bulb can be purchased through your local AEG Service Force Centre (Part No: 647072580).

￿￿Warning! Never use standard light bulbs in your Lavatherm.

￿Isolate the appliance from the mains supply.

￿Screw-off the bulb cover. (The bulb is located at the top behind the door; see Front view).

￿Replace the defective bulb.

￿Screw-on the bulb cover.

￿￿Warning! For safety reasons the bulb cover must be screwed-on. The dryer must not be operated, without the cover in place.

28