What to do if ...
35
Red warning indicator is
flashing, temperature dis-
play shows a square or
error code (F7 or F8).
A functions error has
occurred.
Please make a note of the
indicated error and inform
the customer service
department. Do not open
the appliance door again.
The freezer compartment
temperature is insufficient.
The appliance is in the
operation mode "Cooling"
instead of "Freezing".
Switching the appliance in
the operation mode
"Freezing". For that, please
refer in the "Select
Freezing or Cooling"
chapter.
Temperature is not properly
adjusted.
Please refer to the section
"Temperature Adjustment".
Door was open for a long
time.
Only leave the door open
as long as necessary.
Within the last 24 hours a
large quantity of warm
foods were loaded.
Press FROSTMATIC button.
Appliance is next to a
source of warmth.
Please refer to the section
"Installation Location".
Interior illumination does
not function. Light bulb is defective. Please refer in this chapter
under "Replace light bulb" .
If the door remains open
for more than 5 minutes,
the interior illumination
blinks and is switched off
after.
This is normal, no error has
occurred.
Please refer to "Interior
Illumination" section.
Large accumulation of
frost in the appliance,
perhaps also at the door
seal.
Door is not properly sealed
(perhaps after reversing
door).
Carefully warm the door
seal with a hand-held hair
dryer at those points which
are not airtight (no warmer
than approx. 50°C). At the
same time, shape the
warmed door seal by hand,
so that it is again properly
seated.
Malfunction Possible cause Remedy