OPERATING INSTRUCTIONS

CONTROLS

A BCD

FIG. 1

The refrigerator can be run on 230-240 V, 12 V or LP gas. Changing between these modes of operation is carried out by means of the control buttons positioned as shown in fig. 1.

The energy selector (A) can be set at either "AC" (230- 240 V), "DC" (12 V), "GAS" (LP gas) or "OFF".

An indicator lamp (B) at the control panel flashes when the automatic igniter attempts to light the burner. Otherwise this lamp is off.

The refrigerator is fitted with a safety device that automatically shuts off the supply of gas if the flame goes out. The safety device can be operated manually by pressing the button (C).

The refrigerator temperature is controlled by a thermo- stat (D) when the refrigerator runs on 230-240 V and LP gas.Please note that the thermostat has no "off" position when the refrigerator runs on LP gas.

STARTING THE REFRIGERATOR

All references are to fig. 1.

LP Gas operation

After initial installation, servicing, or changing gas cylinders etc., the gas pipes may contain some air that should be allowed to escape by briefly turning on the refrigerator or other appliances. This will ensure that the flame lights immediately.

To start gas operation:

1.Open the shut off valve of the gas bottle (check that there is enough gas). Open any on-board shut-off valve.

2.Set the thermostat knob (D) to the highest setting.

3.Turn the energy selector (A) to position "GAS".

A ticking sound will be heard and the lamp (B) will start flashing.

4.Push the button (C) in until it reaches the bottom - and hold. This opens the flame failure device and allows gas to flow to the burner.

5.When the flame lights, the sparking stops automati- cally and the lamp stops flashing.

6.Hold the button (C) an additional 10-15 seconds to activate the flame failure device, then release it.

If the lamp start flashing again, repeat step 4-6.

To terminate gas operation, turn the knob (A) to "OFF" position.

230-240 V operation

Before operating the refrigerator, check that the voltage stated on the data plate is the same as the main voltage in use.

Turn the thermostat knob (D) to its highest (coldest) position.

Set the energy selector (A) to position "AC".

12 V operation

Only operate your refrigerator on 12 V when the engine of the vehicle is running - otherwise your battery will soon be discharged.

Set the energy selector (A) to position "DC".

REGULATING THE TEMPERATURE

The position number refers to fig.1.

It will take a few hours for the refrigerator to reach normal operating temperature. So we suggest you start it well in advance of a trip and if possible store it with precooled foodstuffs.

On 230-240 V operation and LP gas operation the refrigerator is controlled by a thermostat and the thermo- stat knob (D) should be set at 3-5. If a lower (colder) temperature is desired set the thermostat to a higher figure.

On 12 V operation the refrigerator works continuously.

TRAVEL CATCH

The refrigerator is equipped with two travel catches. Make sure that both are engaged when the caravan is on the move.

FOOD STORAGE

Always keep food in closed containers. Never put hot food in the refrigerator; allow it to cool first.

Never keep items in the refrigerator that might give off flammable gases.

The frozen food compartment is intended for the storage of frozen food and for making ice. It is not suitable for freezing items of food.

Never put bottles or cans of soft drinks in the frozen food storage compartment as they may burst when freezing.

Most kinds of frozen food can be stored in the frozen food compartment for about a month. This period of time may vary, however, and it is important to follow the instructions on the individual packages.

12

Page 4
Image 4
Electrolux RM 6501 manual Controls, Starting the Refrigerator, Regulating the Temperature, Travel Catch, Food Storage