Before Setting Oven Controls

This range has a fan that will turn “ON” and “OFF” by itself to keep the electronics cool. It may continue to run after the range has been turned “OFF”, but may also stop immediately and then turn “ON” after a while.

Oven Vent Location -Models

with Coil Elements

The oven is vented through the right rear coil element. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. DO NOT block the vent. Doing so may cause cooking

Oven Vent Location -Models with

Ceramic Glass Cooktop

The oven vent is located at right side of the front panel and visible when the oven door is open. When the oven is on, hot air is released through the vents. This venting is necessary for proper air circulation in the oven and good baking results.

Removing and Replacing Oven

Racks

To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.

failures, fire or damage to the appliance.

OVEN VENT

OVEN VENT

Arranging Oven Racks

ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when the oven is hot.

Rack

positions

4

3

2

1

RECOMMENDED RACK POSITIONS FOR

BROILING, BAKING & ROASTING

Food

Rack position

 

 

Broiling meats, chicken or fish

3 or 4

 

 

Cookies, cakes, pies, biscuits &muffins

 

1 rack

2 or 3

Multiple racks

2 & 4

 

 

Frozen pies, angel food cake, yeast, bread,

1 or 2

casseroles, small cuts of meat or poultry

 

 

 

Turkey, roast or ham

1

 

 

Note: Always use caution when removing food.

 

Figure 1

Setting Oven Controls

Refer to the Electronic Oven Control Guide for oven settings.

14

Page 14
Image 14
Electrolux Slide-in Setting Oven Controls, Arranging Oven Racks, Oven Vent Location -Models with Ceramic Glass Cooktop