6
SERVICE
REPLACING THE LINE
SDisconnectunit from the power source.
SRemove the spool by firmly pulling on
the tap button.
SClean entire surface of hub and spool.
SReplacewith a pr e-wound spool, or cut a
lengthof 30 feet of 0.065 diameter Weed
Eaterrbrand line. Use of heavier line
could overload and damage the unit.
Never use wire, rope, string, etc., which
can break off and become a dangerous
missile.
SInsert one end of the line about 1/2 inch
(1cm) into t he small slot inside the spool.
Small
Hole Spool
SWind the line evenly and tightly onto
the spool. Wind in the direction of the
arrow found on the spool.
SPush the line into the notch, leaving 3
to 5 inches (7 -- 12 cm) unwound.
SInsert the line into the exit hole in the
hub as shown in the illustration.
Hub Line exit hole
Line in
Notch
SAlign the notch with the line exit hole.
SPush the spool into the hub until it
snaps into place, while keeping light
tension on the end of the line.
SPullon the line extending outside of the
hub to release it from the notch; other-
wise, the unit will not function properly.
STORAGE
WARNING: Perform the following
steps after each use.
SStopthe unit and disconnect the power
source when not in use.
SCarry the unit with motor stopped.
SStore the unit so the line limiter blade
cannot cause injury.
SStore unit and extension cord indoors
in a high, dry place out of the reach of
children. Store unit unplugged.
SStoreunit with all guards in place. Posi -
tion unit so that any sharp objectcan -
not accidentally cause injury.
NEED ASSISTANCE?
For assistance, or a replacement part
call: 1-800-554-6723.
Safety Glasses 952701645
Spool with 30’ line 952701663
50’ coil of bulk line. 952701550
100’ coil of line. 952701533
200’ coil of line. 952701594